Recent content by jasontheplumber

I've got the tickets, just don't do much else other than smaller domestic installs. Thanks for the input though, much appreciated. JL

Tasty bit of kit, I think I'd be bricking it: 1) when designing system 2) when installing it 3) until eternity waiting for it to explode. #smallcajones

Badly apparently.

Whats a 300/l Mc Donalds plate flow? Or is this some elaborate wind up?

They currently have four electric showers which get beaten to fook by ham fisted clubbies. Any improvement on that shouldn't be too hard, flow rate doesn't need to be spectacular, and hadnt got as far as flow restrictors, still deciding on a suitable system. Never heard of the stuff Norc is...

:o Not sure about that, might be a bit out of my comfort zone! WTF!

Meant Flow rate, apologies, long day. Not averse to tanks, and its on top of a hill, in a small village a long way from the main road - if you can call it that. But will take advice from local water supplier as suggested.# THX

Any ideas on a hot water system for a cricket club? They need: Hot and cold water to 4 mixer showers Hot and cold to approximately 5 other outlets. They are having an LPG boiler put in to provide the heating and to heat a cylinder. (possibly) Very tight on headroom for a gravity fed...

Customer has a sealed system, and keeps on getting air in her radiator in the bathroom which is situated on the middle floor. Boiler is at the highest point in the system with auto airvent above it, auto air vent also on primaries by the cylinder. [Pump looks old and the joints have obviously...

Anyone know the current regs on hot and cold pipework in floor screed? Was going to use plastic in a conduit. Any tips

I have a customer with the above shower cartridge, which is knackered. Have found only one replacement supplier , Lunns .net, but the price is extortionate. 122 quid for a shower cartridge. Anyone know of any other reliable shower spares people?

I used to work for a company called myplumber based in Chiswick. Very good reputation and will explain everything to you berforehand. Their powerflushes used to start at £450 + vat for upto 10 rads, that was last year though. Check them out on chiswickw4 website.

it was a Vaillant 622/2e system. I think it was an Ecomax but didnt note it down. Big old bulge in the exchanger door though.

The front of the heat exchanger had warped, presumably through getting too hot and had melted the air intake tube, that thing that looks like a black plastic horn. The system's only five years old, and all the pipework looks fairly tidy. Someone obviously took some time over it but clearly there...

Thank you, have already submitted my details and am awaiting access. i look forward to picking your brains. Always willing to learn....