Recent content by Jbcory74

Just a mini update! I’ve not touched anything have left it all the same. The bath is working perfectly and heating up within like 10-20 seconds like before. The en-suite is warming up but taking like 4-5 minutes … and the ensure shower does go cold half way through then goes warm again after...

He has said that we are going to have to go down the route of changing the hot water flow switch! I can keep you posted so you know what happens, hopefully this is it!!

We have an airing cupboard in the landing - the wall the other side is the en-suite. He did something in there and then I turned the shower and and tap on on en-suite and no water was running … Then turned on the kitchen tap and it went to 00 still

Yes it’s partially closed still… Nothing was working with it fully open… so closed it and mos thing works yesterday until today…

I just ran the kitchen tap, hot water came out boiler didn’t start… so it must have been the water the bath heated up. This is getting very annoying now!!!

No nothing! Boiler serviced - issues since that. Probs not connected the man didn’t really touch much??? Since that had a new shower bath ran and sink tap fitted in the main bathroom is all. Issues happened before this. Nobody has touched any pipes!

Update… My mother in law has been at my house all day and has said: there was no hot water coming out of the main bathroom sink this morning and the kitchen has been cold all day. My partner got home an hour before me. I told him to use the main bathroom to shower. He did. No hot water so he...

Maybe I should ask him to join this thread…

He came last night… Isolated the shower but we still had an issue with the flow being unable to be on full without it going to 00 and not firing up the boiler. So then he completely turned all water off, and slowly reintroduced it back in while running the hot water tab to make sure that flow...

Thank you. I’ve just copy and pasted your message to him! He said yesterday he is happy to test everything as long as he can get it all working!

But if anyone has ideas for his next visit let me know! He didn’t go upstairs (my little one was going to bed) but did say about the mixer shower being isolated when off anyway, and not always possible to isolate it any other way… I can ask this again when he’s here day time!

Yeah that lol

Unusual, because he said if the fan (not a fan) but the spinning thing) is faulty, usually it stops working with low flow and gets kick started with a fast flow… but ours is the reverse… working with low flow but not with fast… I’ll let you know and try take notes as he’s speaking!

He said “No problem, happy to try anything if it's going to work!!!“ Will keep you updated. Thanks everyone so much!

Thanks! I’ve just sent him the message he will speak to manufacture tomorrow and be coming back up!