Recent content by Jivesy

Cheers, Tried the magnet thing, but only got a slight pull so it probably wasn't powerful enough. It would be pretty amazing if they hadn't reinforced them properly, but, i guess, not impossible. I did think that maybe they had been fitted too tightly, but not sure, 12+ windows all fitted too...

thanks for the replies. There are three screws down the edge: one in the middle, one about 6 inches from the top and one about 6 inches from the bottom. Although the photos doesn't show it, the sealant on the bullnose does have a gap, but it is covered by the trim; which is stuck to the frame...

Sure, hopefully one attached. Sorry, not a great description from me, but basically every corner, on every window, has bent out to some degree. Enough in some cases so that the window doesn't close fully on the hinge side (there isn't a straight edge on the frame, as the top and bottom has...

hello, last spring we had all our windows replaced with new upvc windows. over the last couple of months all of the windows's main frames have bent outwards in each corner, in some cases opening a gap of 3mm (the larger windows are warping more than the smaller ones). I guess that the outside...