jj4091's latest activity

  • J
    jj4091 reacted to denso13's post in the thread Boiler Replacement with Thanks Thanks.
    The Vokera Pinnacle is my go to at the moment, a 1:13 modulation ratio.
  • J
    jj4091 reacted to vulcancontinental's post in the thread Boiler Replacement with Thanks Thanks.
    Yes, that's what I was alluding to. If the boiler cycles it affects efficiency and also noise as the fan runs slower for heating (80% is...
  • J
    jj4091 replied to the thread Boiler Replacement.
    Sorry never noticed that .Thanks. So does that mean I might be better looking at a manufacurer whose boiler modulates lower. Must admit...
  • J
    jj4091 reacted to gas112's post in the thread Boiler Replacement with Thanks Thanks.
    yeah that will be plenty for the shower
  • J
    jj4091 replied to the thread Boiler Replacement.
    That pretty much describes our house except that we have uninsulated cavity walls so I guess the heat loss would be similar. Would you...
  • J
    jj4091 replied to the thread Boiler Replacement.
    Now I only have a shower I assume 12.4 litres/min would be ample, as they claim it will be for a shower.
  • J
    jj4091 replied to the thread Boiler Replacement.
    When the boiler was installed we had a large cast iron roll top bath that took too long to fill from the boiler that was in when we...
  • J
    jj4091 reacted to denso13's post in the thread Boiler Replacement with Thanks Thanks.
    Just one, it is only an indication of what size boiler is required, it isn't exact.
  • J
    Could it be that others have already done investigations into whether it would be worthwhile and decided to walk away. I would, just...
  • J
    jj4091 replied to the thread Tiling over old plaster.
    Personaly I would have it skimmed first. A lot less trouble and probably do a better job of the tiling
  • J
    After another breakdown I have decided it might be time to replace our 16 year old Ideal Logic 35. In order to get an idea of the costs...
  • J
    jj4091 replied to the thread Fridge Freezer poping sound.
    Try defrosting it
  • J
    jj4091 replied to the thread No hot water then very hot water!.
    Not a heating engineer but. Ours failed again within 12 months after just replacing the seals. I would suggest getting it done now and...
  • J
    jj4091 replied to the thread Drill Porcelain Patio.
    Sorry but I have to disagree those bases are designed so that any flexing is taken up betwen the base and the post. Never had a problem...
  • J
    jj4091 replied to the thread Door mech.
    https://www.diynot.com/diy/threads/upvc-multi-point-lock-latch-wont-spring-out-fully.544642/
Back
Top