jj4091's latest activity
-
Jjj4091 replied to the thread dont understand height of these step ladders.I suppose it depends on how safe you feel standing on the platform and how tall you are.
-
Jjj4091 replied to the thread Samsung BT621VDST Oven not working - red bar.Yes it would seem like you have an elecrical fault which will probably need a visit from a suitably qualified engineer. Have you tried...
-
Jjj4091 replied to the thread Hollow red brick.Have you thought about using hollow wall hangers https://www.screwfix.com/c/screws-nails-fixings/hollow-wall-anchors/cat7280101
-
Jjj4091 replied to the thread Samsung BT621VDST Oven not working - red bar.So do you mean the upper element does not heat up in single mode? If so does it heat up in the other modes or is it just that you don't...
-
Jjj4091 replied to the thread Shark intermittent brush roller..Don't know if that is a common fault or not. Does the brush roll motor indicator light up red, flashing red or green when the brush...
-
Jjj4091 replied to the thread How to seal around washing machine pipe?.I said "something like this",meaning some sort of suitable ready mixed filler. Should have been clearer. White can't look any worse...
-
Jjj4091 replied to the thread Alternator Repair.I don't think it is just the rating of the iron but also the size of the tip and the thing that you are trying to solder. If it applies...
-
Jjj4091 replied to the thread How to seal around washing machine pipe?.Something like this should make it easier for you...
-
Jjj4091 replied to the thread Drainpipes spill water onto patio.To me it looks like you need to remove the grid and clean out the gully, fit a 135degree bend to the kitchen waste and take it below the...
-
Jjj4091 replied to the thread Cooker Hood assembly.https://www.diynot.com/diy/threads/cooker-extractor-fan.575142/ The link no longer works for me, so you will probably have to contact...
-
Jjj4091 replied to the thread Drain cover handles.We had one in our imprinted concrete and tried everything, apart from one of those lift dollies (that I have never seen before). I ended...
-
Jjj4091 replied to the thread Unknown pipe by front door.Looks like it's possibly some sort of test point, but in my opinion you need get your supplier to check if it is live or dead and cap it...
-
Jjj4091 replied to the thread Help I cannot work out the pipes under the sink.Look at the pic's here and lay your bits on the floor. out as best suits your set up...
-
Jjj4091 replied to the thread Feather edge clout.I was taught to hit the point of the nail to blunt it, with the head resting on somehiong hard,before hammering into thin wood to help...
-
Jjj4091 replied to the thread Unknown pipe by front door.Is it on your propery or does your front door open on to a public pavement