Recent content by jmeader43

On the Premier Elite 24 I can program the zone as Normally Open as the terminals on the Optex Receiver with the main wiring that feeds the Transmitter are NO and COM. There is a deep sounding buzzer that was triggered when the beam was activated so this could be the reason for the relay. I will...

I have a couple of these driveway sensors that work fine and I’ve just had to cut all the wiring out to replace the old unbranded panel The model is this one: AX-100PLUS I would like to have the driveway sensors make a noise on the speaker next to the alarm panel like before I cut it all out...

Thanks for the reply I will look into those copper cables and perhaps it will allow me to run a 20 metre cable length from the power splitter at the TV up to their shed

Thanks for your reply and I’ll take that onboard. It’s a customer supplied aerial and I’m currently looking at some options. Aesthetics are driving their decision as it’s his parents house and there is a lot of tension between their son (my customer) and them over where it needs to be...

This model: SLx 27895K4 Outdoor Aerial, Digidome For TV Digital Freeview HD 360° Omni Directional Amplified Antenna with Integrated 4G Filter and Full Installation Kit,White It comes with a 10 metre RG6 cable and 12 volt power supply that connects to the aerial I currently have a 2 metre coax...

Great, I have fitted several of those so will go for that

I’ve fitted a new Eaton branded Scantronic 9448+ wired panel that a customer supplied to replace the same old one that was 20+ years in service I’ve found the outdoor siren isn’t working at all and wondered if I can use any brand of wired siren or would this panel only work with selected...

I tried to but it doesn’t acknowledge any commands by reply sms like it says it supposed too

Hi mate, yes thanks for that the problem I’m having is it doesn’t respond to any command I sent to it and it’s supposed to text me back confirming when I’ve made a change to it. There is an app but it says it’s not available in this region, I’m in the UK so I also tried to VPN to change my IP to...

Does anyone know how to test one of these? It’s brand new with a working SIM card from a previously same model but the SIM card holder was broken I’ve powered it up and it’s got mobile signal with a slow flashing red led and I’ve connected a 12V pc case fan into the following for testing the...

She won’t arm it because she doesn’t want the system at all She says she doesn’t trust the alarm to work properly and my personal opinion is it’s more to do with there being 2 cats that are quite sick and prone to stress so she doesn’t want to scare them. She’s a very troubled person with a...

To clarify she locks the door She won’t set the alarm out of spite There is a SmartCom with single path WiFi

Yes The husband wants the wife to arm the system when she leaves the property She refuses to use the system and it causes the husband a lot of anxiety over the property being at risk There’s currently a door contact on the front door set to Entry/Exit There’s also a PIR in the hallway set...

I’ve had a reply from the Facebook group Texecom Technical Support Group which says Could you not just set up as a timed set. Say 30secs and then as long as the detection is not say in the hallway that would be ok.