johnny2007's latest activity

  • johnny2007
    Check if it's still under warranty. One of my grohe taps developed the same problem and they changed the cartridge free of charge.
  • johnny2007
    johnny2007 replied to the thread Happy Easter everyone.
    After this pearl I believe everything you say :ROFLMAO:
  • johnny2007
    johnny2007 replied to the thread Happy Easter everyone.
    You've never been to a church. Cathedrals have lots of space around seats so a 2000 seat could easily get benches for another 1000...
  • johnny2007
    johnny2007 replied to the thread Happy Easter everyone.
    WTF are you on about??? 800 seats is a small church. It's 40 rows of double benches. Total footprint of about 10m x 30m + some space on...
  • johnny2007
    johnny2007 reacted to aveatry's post in the thread Door catching floor with Thanks Thanks.
    When planeing do not go off the edge from the middle or you will push off or splinter the end, stop before the end and the start again...
  • johnny2007
    johnny2007 replied to the thread Happy Easter everyone.
    Been to church today, it was packed and many people were following from the outside screen. As a rough count, 8 people per bench, there...
  • johnny2007
    johnny2007 reacted to Koolpc's post in the thread Happy Easter everyone with Thanks Thanks.
    I went to Easter vigil mass last night. It was greatly attended. It was a lovely service that lasted 2.5 hrs. Jesus has risen. Alleluia
  • johnny2007
    johnny2007 replied to the thread Anyone used one of these?.
    I have a wooden manual of these. Don't know how good it would be to your wrist if the blade jams ..
  • johnny2007
    johnny2007 replied to the thread Nice little car boot find.
    I have one of these with a nice hole in the middle of the blades. One of my boys cut a cable without checking if it was live...
  • johnny2007
    johnny2007 replied to the thread Door catching floor.
    Planer with a good blade won't chip it. Use masking tape where you're planing so to minimise chipping further. Before you refit, seal...
  • johnny2007
    johnny2007 replied to the thread Weighing in copper.
    Here in London they pay for clean copper when there are soldered joints.
  • johnny2007
    johnny2007 replied to the thread Happy Easter everyone.
    You believe only things that suit your narrative from MSM. You either believe all of their "news" or not.
  • johnny2007
    johnny2007 reacted to SPLINE's post in the thread Happy Easter everyone with Thanks Thanks.
    The risible rise of islam in Britain has been entirely at the expense of the British taxpayer, and with the collusion of several...
  • johnny2007
    johnny2007 replied to the thread Happy Easter everyone.
    Of course Himmy, of course. Anything is possible in Fantasyland.
  • johnny2007
    johnny2007 replied to the thread New wooden door swelling....
    I built many garden gates in my life always in summer and sealed them properly. 12 mm gap on sides and top, 25mm bottom. In winter the...
Back
Top