Recent content by Johnnylynch

Removed archway and need to fill and level to existing plaster. What method would you suggest? Archway removal by Johnnylynch posted 25 Oct 2020 at 8:51 AM

thanks all.

JohnW2, yeah thats pretty much where i am. don't think there is an issue with product, its in full working order in what i expected to be 32amp fuse. im happy to use extension in short term and will look to getting cables checked/upgraded if it becomes an issue.

it does work on my two 32amp sockets inside house though, not sure why garage is 16amp but sure it was enough when installed.

(Yes, I saw that. What do the instructions say about the electrical supply requirements?) i dont have the instructions to hand so not sure if any specific details but dont think so as i did have a read through when issue originally happened to find solution to fuse tripping.

HI, yeah standard 13a plug. don't believe it requires a 32 supply , have seen a few more comments where its the initial switching on that is tripping it. i'm happy enough the product is safe when connected to my internal sockets which are 32.

this is the saw - http://pingtek.36.ekmpowershop.net/pt48250s-table-saw-21-p.asp

Hi, i does work fine when used on extension cable to internal 32amp socket circuit. seem like its just the initial startup that is tripping the 16amp fuse. if it was causing a dim to lights id see it in the garage and it certainly does not seem to be.

okay thanks both, guess ill just need to run an extension cable into the house when using saw. cheers.

Hi, I bought a new table saw for garage but it requires a 32 amp circuit, (trips the current 16amp). Can I simply replace the 16 with 32? Load on consumer says 80amp and current in 2x32amp sockets, 1x32amp cooker, 2 x6amp lights and 1x16amp for garage. Obviously that's more then 80amp but...