Hi All, not been on here for donkeys so apologies if I'm not posting in the relevant section.
Question: is it worth trying to repair an Indesit Dryer IDC8T3 thats making very loud screeching noises. It's fine until drying for about 20 minutes and then it's unbearable to tolerate. If i stop the...
Just to let you all know i sorted this out now so thankyou. Insert arrived today and was about £13 including delivery. All a perfect measurement by the top part where the plastic cap goes on, it was slightly bigger by 2 mm so had to really squeeze hard to get the cap on and screw it down...
17mm socket just arrived from Amazon. Only cost a couple of quid and was worth it as I've got the baby out but don't have a clue where to get a replacement from? I'll have a look on Lunns.net as suggested, any other recommendations please?
Thanks
Joni
Hi Guys, finally got round to tackling this today and I have managed to get the tap head off with ease however, the brass head gear is proving to be a pain to losen off. I am right in turning it anti clockwise?
Just put some more rock kill on it.
Off to get a 17m socket head for my socket...
Thanks for the replies guys its given me some hope. There's no way the miss will allow me to knock through the master bedroom wall into the bathroom, so that's out the question but a very good idea.
I've turned the tap head fully round and defo no grub screw hiding in there so i'm just hoping...
Thanks for your reply Blup. I wasn't aware that some taps were unservicable... would explain things. I took the side panel off a few weeks back and it looked like there was very little room for maneuver as i couldnt even see the taps from underneath. I will take the panel off again and take a...
Morning.
I have a dripping bath tap that's driving me insane. Fixed the odd tap before but it was simple, this one is challenging me.
Both hot and cold are quarter turn and the leak is from hot (left hand side). The hot tap turns further than it should do when shutting off, so maybe the tap...
Hello,
Washing machine is about 3 years old Whirlpool 1400spin AWO10781
It keeps making a clciking noise and the door lock is flashing even though the door is locked so this isnt allowing the cycle to start.
The filter has been emptied after noticing the problem but won't tighten back up...