Recent content by Jonny brown

  1. J

    Baxi 105e fitting wireless thermostat

    Good morning I'm still using a baxi 105e with a mechanical clock . I'm thinking of replacing it with a wireless room thermostat ( it looks a easy job correct me if I'm wrong). My question is after I fit the wireless stat will the boiler just keep the burners on until the room reaches...
  2. J

    Baxi 105e pump noise

    Dodgy bearing ? . Maybe you over tightened it when you installed it and it's vibrating
  3. J

    Baxi 105e inlet manifold

    That looks ok as it's not touching the micro switch . It will probably drop further when the system is cold
  4. J

    Baxi 105e inlet manifold

    Don't forget silicon grease on the pump rubber washer and take the screw out of the automatic air vent
  5. J

    Thermister issue?

    The return valve filter is on the right hand side pipe with a blanking nut on it . There's a video on YouTube telling you how to remove it . Considering you'll need to drain the boiler down to clean the filter might be worth looking at the pump
  6. J

    Thermister issue?

    Just change the thermistor it costs £3 delivered from eBay. If I can remember right it's just a 13mm spanner to screw it off and replace it . If that doesn't work phone your gasman
  7. J

    Strange noise from 2011 VW polo

    Speedometer cable?
  8. J

    Baxi 105e dripping when hot water is running

    Thanks everyone for your help it worked (so far anyway) . I think it was leaking from both ends the Bush nut looks like it's been leaking and the tiny o-ring on the other part disintegrated when I pulled it out . Thanks again
  9. J

    Baxi 105e dripping when hot water is running

    Hi sorry to be a pain but I've just received another bush nut from ebay and its the same as the original part that was missing the white plastic insides!. Could I be missing something
  10. J

    Baxi 105e dripping when hot water is running

    Thanks I'll contact the people I purchased it from
  11. J

    Baxi 105e dripping when hot water is running

    does this bush nut look incomplete? Shouldn't it have a white plastic bit in the middle and not just a hole?
  12. J

    Baxi 105e dripping when hot water is running

    Just a quick update. When I got up this morning there was a drip of water on the valve . I had a sniff and it smells chemically, it's certainly not fresh water . I might just change both ends to be sure . Thanks again everyone
  13. J

    Baxi 105e dripping when hot water is running

    No I haven't topped it up at all . It was serviced in April, the engineer could of topped it up
  14. J

    Baxi 105e dripping when hot water is running

    Can I replace the Bush nut in situ or will I need to replace it with everything taken off ?
  15. J

    Baxi 105e dripping when hot water is running

    The water is dripping at that joint.
Back
Top