Hello again - there is an issue with my CPC order, looks like they are out of stock. Is this CC Driver compatible please? Or is the Wattage output slightly too high? (I need a dimmable one) - https://www.amazon.co.uk/gp/product/B076QHQ5HJ/ref=ox_sc_act_title_1?smid=A3P5ROKL5A1OLE&psc=1
Perfect, have gone for that - thanks for the advice, and education regarding Constant Voltage and Constant Current drivers.
Thanks for the help guys, really appreciated.
Thanks.
I've just done that - the head works on another working fitting, so it must be the driver. Using an electrical tester, there is live showing on the wire between the driver and the head. I can only assume the driver has gone faulty and the power it's supplying to the head is not correct...
Hi all,
I live in a new build that is now 6 years old. One of my downlights has stopped working in the kitchen. I've been searching and searching to see if I can find the exact same unit but I can't find anything.
Any ideas of the make/model of this please? If not, is there an alternative with...
Hi, just to add, I have more or less the same setup. In the past 9 months I have had this happen twice, I shut the door and as I walk to my car, the alarm has gone off, triggered by the Hall PIR.
Never been able to figure out what caused it. Hasn't happened now for a couple months.
Thanks - I have a spare wire, so I am going to go ahead and connect it up to avoid blowing my face off when I have to change the backup battery in a couple years!
Thanks Bianco. Last question...
What about connecting engineer hold off (PGM @ the panel > ENG HOLD @ the deltabell)?
Or am I right in saying this not required as "Self Activating Engineer Hold Off" would be activated when in Engineer Menu which disables auxiliary inputs?
Hi all,
Sorry to hijack this, but thought better than creating a new thread. I've bought a Pyronix Deltabell E G2 Module to go with my Pyronix Enforcer V10. I am after some help for how to wire it up as I'm having difficulty interpreting the instructions between the Deltabell E Instructions and...
Thanks Sparkymarka, that is mega helpful. I was lazy and stole the layout from the developers website. My kitchen design is slightly different as I have lader (floor to ceiling) units where the table is. I've hacked a more representative view in photoshop. Given this I think the PIR is still...