That's a fair point and I have no issue with the way you expressed it. I found Dan's way of saying things put me in a defensive position.
The trouble is the house was built in 2006 and the CH/HW work was apparently done by people with the relevant qualifications. But I have found all sorts of...
Of course not. But what is wrong with someone bettering themselves and educating themselves? Many people wouldn't want to do your job and will happily call out a professional. And of course if I was getting a whole heating system or water system installed, I would never do it myself. But...
Of course not all plumbers are rip-off merchants...just I have had some bad local experiences in the past few years which caused me to want to be more self educated and do more things myself. If you knew more about the type of behaviour I have experienced I think you would understand.
Like I...
I am not quite sure what your beef is here. I am a quick study and practical. I like to learn about things and do as much myself as I can. I studied very carefully before installing the EVOHOME and talked to other forum members who were keen to share and had spoken to OSO about where to install...
Believe me I do know how to undo a nut! But this was the only tool I had that would open up to 50mm. I have also installed a complete EVOHOME system for both water and heating without any issue and done plenty of minor plumbing jobs like changing tap fittings etc. So I am not dim! But I just...
I have an OSO 210l indirect series 20 water tank. In the last 6-12 months it has developed some symptoms
1) When the hot water is really hot, it affects the pressure from the cold water. This can be particularly seen if I flush a toilet, where the cold drops to practically nothing while the...
Thanks for the suggestion, I appreciate it. The reason I came to the conclusion it was not set correctly was because I could hear water gushing through the bypass loop when the heating was on.
I apologise....I was fighting the auto correction on my tablet while typing the initial post and it mangled USV into UVC! I didn't mean to confuse.
It is an S-Plan set-up with 2 motorized valves.
Hi,
The house was built in 2006, and I was just reviewing the plumbing and noted the balancing valve was set completely wrongly at position 1 (it goes from 0-7). This means it is almost fully open and I have been wasting energy heating up the bypass loop all these years.
I understand that...
It is a Siemens REV24 RF thermostat that comes in two parts. The receiver (on the wall), and a moveable remote with display. The LEDs I am referring to are on the receiver on the wall.
Here is a link showing one...