Recent content by just_thinking

did you get my e-mail regarding fitting of the hank bushes.

just goes to show CORGI have not kept up with the changes in flueing.

pcb problems on these boilers are very common the smallest short circuit can end the life of pcb sooner than later. pcb has to be correct for any more tests to be carried out hopefully transformer is not damaged. good luck.

you could have damaged pcb,discon electric to appliance undo 4 small pozi screws pull it out look at back of pcb,are all solder runs correct is there any burning marks on solder posts.

does burner light during an ignition attempt,pump could be in over run mode so try.heating with boiler cold.

opps sorry did not mention new type of pcb kit is for suprima UP TO 100. so all below 100 will be new type pcb kit,probaly when stockists run out of standad little brown box pcb,they will be more available.

hey i bought a new pcb for suprima only to find instead of in neat little brown box but now a huge box as pcb is now replaced by a kit.including complete controls panel loads of leads(some not req,like ikea furniture)and loads of instructions.all was ok but over heat stat fell apart when trying...

please can some one tell me why baxi-potterton have redesigned the pcb on suprima model and why does the over heat snap off in fingers when trying to remove push on leads. to fit new pcb is a bit of a job as all leads need to be changed,very trickey if boiler is hot. pcb is now in kit form,in...