Recent content by Jxta

Problem solved! Thanks again to both of you, I really appreciated the help. Hive was an individual investment and not just a stab at fixing this, thankfully. Thanks. I previously worked in a technical support team and I try to pay the logical approach forward.

Thanks guys, I really appreciate the help so far. I will try this as soon as I am home from work and report back. Stem - can you explain why I don't need Hive in gravity mode? I thought it needed to be as I have a cold water tank in the attic. I think I might know what has happened. During...

There is a wire on Hive terminal one (yellow), which I presume is the wire going to position 9 on the block connector.

Trying to give you as much accurate information as I can just now. Current state: Hive manually set to on for HW an CH link Boiler is not running - sitting with the standby light (solid amber) link Motorized valve light on for CH only link Motorized valve at mid position (CH and HW) Hive...

Just been up looking at the wiring again and realised I have a made an error - discount the second symptom I gave you for now, I was checking the wrong wire. When the fault state reproduces again I will re-check the voltages. I had correctly checked the CH circuit (white wire) but not the HW...

Stem - Correct, the cylinder thermostat was a straight swap of the wires. This fault happened suddenly around a month ago, before Hive was installed, the system worked perfectly up until this point - I walked in one day and the house was melting, the boiler had kept running all day when the...

Hi Stem, It's one 3 port valve (Y). I'll have a look at the wiring when home. I'll take a picture too. Thanks, Gordy

Hi Folks, I have a problem with my boiler/CH/HW setup which I am having difficulty troubleshooting. There are two scenarios: The programmer/timer is off for both CH and HW: Boiler is running, and continues to do so until next program change or reset (button or mains power off/on) The...

Hi Ceres, Thanks for your reply. The house was built in 2003. I will seek plans from the council as well as contacting the factor to get their view on the subject. The vegetation certainly isn't low, or hasn't been maintained in this way. It provides no line of sight for the turning area, a...

Thanks guys. I realise now property factor was the wrong term to use, simply I pay factor fees to maintain general grassed areas and play parks which includes the area in question. I'll check and confirm the measurements in my Title over the weekend and post back. Thanks, G

Hi all, Based in Central Scotland, looking for advice on a fence I want to move within my boundary. The below image outlines my land deeds, the yellow line represents my garden fence currently, the green line is where I would like to move the fence to. The area marked with blue lines contains...