Recent content by kabong

Well it all seems to be working! TBH I am a little lost as to what I've tested and what has changed, if anything. From what I can tell everything is currently as I had installed it. The element came pre-wired, so I only touched the switch end of things, but I didn't adjust that yesterday. And I...

I will. Many thanks again.

Yes it makes a slightly louder humm

I do but my zones are all old school with knobs on pipes.....

I'm going to tidy up the wiring and see how it performs tomorrow morning after the timer comes on.

The new stat is now clicking off at 55 so it seems to be working.

It's on sink. I've stopped using g the boiler now as the energy costs are so high and its hard to isolate the central heating from it. I only have this coming on for a short bit in the morning and then adhoc if the kids want a shower which is very random times!

Ok I've powered on off a few times and can definitely hear a very faint hum and water type noises when it's on. I'm very confused. It seems to be working but amn't I back to the setup where it wasn't working?

I just put stat to 60 and I can hear faint noises. This is the new stat.

I can't hear it working. I just turned the new stat down and it clicked at around 50 but still no noise.

Is it just down to the resistance readings so? The old stat is out and reading 0.1

I've just put the new stat back in and got the same measurements. I'm confused TBH

I let my daughter have a shower to use up the hit water. It's now showing 223v on both sides.

I have just retrieved my old stat from the wheelie bin. Might give it a shot.