Recent content by kaddour

Can someone knowledgeable confirm if I can replace the old Myson CP61 "head" with a CP63 or CP53 "head"? with the hex socket screws while keeping the old Myson CP61 body/flanges. Thanks

Good morning all, the pump in our "Potterton Puma 80e" has stopped working. I removed the head and tested it. In needs an initial manual spin to start running. I then replaced the capacitor to no avail. I would like to know which compatible replacement heads would fit into the existing pump body...

Greased the pin but didn't work. Ended up replacing the flowswitch and that fixed it. Thank you Gasguru for your support. Really appreciate it. >>In the long run it would have been cheaper for the owners to have ripped it out the day after install and get something decent. Any decent model you...

1-You mean unscrew this part (red Arrow)? 2-What sort of grease would do the job? Thanks again.

Put in a new microswitch. Now the red light on the circuit board stays on and the burner restarts then stays on ALL the time while the tap in open and even when I close the tap!!! Also the burner started by itself when NO tap was touched (all closed)!!! Please help.

The Red light on the circuit board does indeed go off while the tap is still open. Will now look into the microswitch/flowswitch. Thanks Gasguru for the suggestion.

When I first open a hot tap, the boiler kicks in and starts running as normal for about 45 seconds and the hot water comes out very hot, then the burner stops while the tap is running hot, then the boiler tries to kick in again (quick little usual sound just before the burner goes on) but DOES...