Right okay so for example, remove the wire that connects the 2 sockets that are already there.
From old socket 1 Put a new wire in up to the new socket
Then put another wire in the new socket that goes to old socket 2. Have I now extended the ring final?
Sorry to break it down step by step...
I think I’ve found a diagram for what you mean..Once isolated is the dotted blue line where I would cut to separate the wire into 2? The extended ring is now the orangey/yellow lines to where the additional 2 sockets are?
so anywhere on the ring between 2 sockets is where I could make this cut...
Thanks very much for that reply. The cables come in from a hole in the bottom of the back box so I’m presuming at the moment until I check in the morning that they’re coming from underneath the floorboards. If the brick wasn’t in the bottom of the fireplace I would of come up through there I...
Hello there, I’m wanting to add a spur to a socket that’s on a ring circuit, the socket I’m spurring off is in the skirting board and in the alcove on the right of the chimney breast. It’s on a 32a RCD.
I’m after some help and ideas in the best plan of attack to route the wire as I can’t come...