Recent content by Kdyteejay2

Problem solved, thanks for helping.

Is there a diagram i can use to identify these parts? I’m obviously ok with the battery.

Hi everyone, I am unable to set the alarm for my house. The reason is I get a message saying there is a tamper alarm on one of my bedrooms. I went into engineer mode and checked the pir and everything looks normal to me. I still get this message. Because the bedroom is obviously a part of the...

Thank you so much

Also meant to say the cover is still off the pir. I have now put battery back in and closed pir. The message on the panel has changed to test failed but doesn’t say location (living room). The pir is sitting in my kitchen now.

Hi I have a new issue with my pyronix enforcer system. I have a decorater coming tomorrow to hang wallpaper. I went into engineer mode, unscrewed the cover on a pir, removed pir and bracket from the wall. I didn’t alter anything in engineer mode but when I took option to exit engineer mode the...

Pretty sure the lid is flush so must be the latter . Thanks for the information.

I’ve done that but it doesn’t permanently remove the message. Every time I set the alarm it appears again. What I would like to know is how I can stop the message from reappearing.

Thanks for the advice. Can I ask all how I clear this message from displaying.

My bell looks like this. Is this a MK2?If so should I try to get the system to relearn or buy a new. One?

I changed the battery in my external bell. AFAIK you shouldn’t have to program anything but when I tested to see if the external bell would sound if I simulated break in the alarm sounded at the key pad but not the external bell. Does anybody know if I have to get the system to re-learn the bell?

Just been back to it. Redid change inputs and saved it. Is now working fine. Thanks to all that posted.

In appendix f of programming manual under fault wireless mismatch it describes as’there is an input learnt without having a type assigned to it’. Under solution it says ‘assign an input type in change inputs’. I went to change inputs, went to living room and it already seemed to be configured...

Can I do this without taking pir off the wall. I remember when I set it up it was all done before mounting in position.

I’m not sure how ( stupidly I think I was in master manager and when I removed the pir cover I triggered the alarm) . Then I thought I had to relearn the pir after inputting new battery. You say I shouldn’t have to relearn after changing battery. Should I just have to go into engineer mode...