Right, ok so I'll buy a new 15mm valve and screw the head off of it and replace the one that's leaking. I am going to do this live without draining down so I don't lose a lot of water. Should only take a few seconds. I'll drop the pressure in the rad and let the heating cool down prior. The...
Hi guys,
Require a bit of help please to replace this part that looks oxidized. It only drips a tiny amount when the heating is on and it's green for some odd reason. Can someone provide a pic of the part I need to replace it as it looks different to a normal convention rad.
Repair sorted today by noon. Thanks for all the advise. Used Checkatrade app and got someone very keen who did the job promptly and carried the parts in his van stock that was listed above. No leaks after 8 hours and pressure seems to be holding out ok so far. Cost £80 call out and part £40 so...
Hi. Two days after having a new kitchen fitted out Worcester boiler has a drip coming from underneath. It's from the hole on the black plastic. I have added an image.
Also the pressure has been low and dropping the last week or so.
Any ideas please?
Okay I did have that it mind but where does it end hey lol. I was going to cut it with the junior axe saw but thought I don't want to risk the pipework getting chewed up. I did try pliers but it wasn't having it. My next rad that's needs attention doesn't get hot, just loop warm, both valves...
Thanks, I already done the job earlier. Didn't go in blind but still came across minor problems as u can imagine. Lock shield valve caps on all the rads had rusty screws and couldn't take them off but just hoped they shut off by turning fully right. Released the pressure from the bleed valve I...
Just to add to the above. I am keen on DIY especially plumbing, about 10 years ago i tried to get on a heating engineers course in Bolton Manchester but due to lack of government funding the centre closed down so i was gutted. Ended up going down the IT route which i regret in some ways as it...
Hi all,
I am not a plumber/engineer so appreciate any help.
I am wanting to change a rad valve downstairs on a pressurised combi system. I have watched several videos on the Tube but cant decide which is the best way to do it without doing a complete drain down which is time consuming.
My...