Sorry to dig up an old thread but...
Has anyone got an exploded diagram of this valve?
I have a service kit which has springs etc.
Is there a diagram anywhere on the net?
I can`t paint anything on the outside wall as it is virtually against another wall....unless I can get a very thin man down the gap with a brush.
Think I will go for the insulated plasterboard soloution with no vapour barrier
If that fails to work then I think its got to be a plastic...
The wall is cold but not damp.
Are you saying that the vapour will permeate from the wall side into the back of the insualtion...or the other way around?
I intend to foil tape all the room sided joints, but I think you are saying that the mould will grow behind these taped joins????
Spot on!
Are you saying that the water vapour will move into the room more or go out to the walls?
I`m trying to eliminate the mould growth by the best possible means.
During the winter its heated and for the last few months has had a de-humidifier working to keep it down.
I`m still...
Hi
Thanks for your advice on the wall insulation problem.
Could I mail you to clarify the details ( you are the only one that seems to have worked out the problem! )
Thanks
Keith
The porch is heated because we have two dogs that sleep in there at night.
The outer walls are built on proper foundations and a warm floor was created ( poly insulation, 1000 gauge DPC and floor screed )
The floor slab is BONE dry.
The walls have a DPC at the same height as the house...
We have a single skin porch on the side of the house.
Its constructed on the front and rear faces of brick. The side wall, which is against the neighbours wall with a 12" gap, is high density concrete block.
I removed the plasterboard which was batterned to the wall with a small air gap as...
I think the light comes on to show that the fan/APS has opereated and stays on if there is a problem. If it goes out the manual says that the fan and APS switch have been proved.
Can you tell me if the same light indicates anything for the primary circuit though?
Sorry to hijack the thread...