Hi, thank you for your speedy reply. Yes, element was tested. To be honest I think the one that I replaced must have been okay as I couldn't see anything wrong with it !
I think you may be right. If it is the fan is it worth replacing or shall I just settle at buying a new oven?
Many thanx
Hi All,
My hot point oven keeps tripping out the electricity. From googling, I thought it'd be the heater element but it still trips after replacing it.
The facts
- it's a Hotpoint 6118 de luxe (fan oven)
- Grill works fine
- light works fine
- when oven switched on, the fan starts to turn...
Please can I communicate my sincere thanks to all of you who have valuably contributed to my post.
Agile, you helped me out before and you were spot on. I have the utmost respect and appreciation for the advice you provide.
Slugbabydotcom,Tterrydoh, Piers1989 - thank you also most...
Dear all,
I hope you can advise me please.
My tenant has complained of hot water not being consistent (ie a string of cold water shoots through intermittently).
I've had a plumber look at it who has quoted for the following parts to be fitted to a Heatline Vizo 24 to fix it. Please could...
Dear Tony / Gazdaz,
Thank you soo much for your help and correct diagnosis. It was the brass pin that wasn't retracting fully. I've loosened it up and lubricated it and it works just fine now!
Thank you again, I am over the moon and I absolutely recommend you both and this site!
Regards,
Kelly x
Dear All,
if any of you kind souls could help me with the next step I would be extremely grateful! I'm having second thoughts now on whether it was the dhw switch I was trying to open. It does seem like it's the diagphram that is likely to be split or that the pin is sticking. Am I going in...
thank you so much for your helpful post. You are absolutely correct. The hot water light stays on all of the time. The ch light doesn't come on at all and the heating seems to have packed up working altogether!
By the way, I confirmed it is an glow worm compact 80e (not100e).
From...
Thanks for taking the time to reply Tony. I've read through some of your previous replies on 100e boilers. Very useful!
As for your reply, I'm quite practical in nature and following up on your tip on FAQ, I've noticed the overpressure problem is probably caused by the boiler being connected...
Dear experts,
I'm in desperate need of some of your expert help please (a friend highly recommended this site). I have a glow worm compact combo boiler 80e in my bathroom.
Problems
The boiler works but when the flame kicks in its only heating the water for about 1 min or less, the...