Recent content by Kelvin Schutte

These two greys are from the 4 core flat twin and earth which come from the CM 707 units, Brown and black connected to A an B respectively at the CM 707 end and the other end in my junction box by the motorised valves. See attached PDF. I was assuming I would disconnect the black and browns...

Hi, So the two black wires from the two Honeywell controllers go to the two MV's on the terminal block, the Browns from the same cables (honeywell units) go to the Live IN on terminal block, the greys as suspected are disconnected. I've figured out im going to need 2 x single channel receivers...

Sorry for the delay ha ha will check over the weekend

That’s great news ….. Will update over next couple days many Thanks Kelvin

This is brilliant thanks I will bring my multimeter home and bell out which brown and Black cables (then label) come from which thermostat (lounge or hoose) many Thanks Kelvin

Black flex at the top goes to said valves. Easy enough to fit hive receiver here ? Any wiring diagram for hive receiver to wire into this junction box would be brilliant. many thanks in advance Kelvin

Yeah sorry for the confusion I meant the receiver that needs to be near the mentioned valves. I will take cover off and have a good look and take some photos Thanks

Ha ha yeah I know !!!

I have found the valves and there is a electrical junction box right by it I will take a pic tomorrow, I assume you mean the hive hub will need to be wired here and not by the boiler in my kitchen? Also will i need two hubs for each zone or can the hub switch multiple zones? Many Thanks

Is this still a relatively easy install wiring to motorised valves ? many Thanks kelvin

Thanks for the reply. To be clear I was going to run a 5c flex 1.5mm from the hive box to the boiler (see attached photo) LN + E and use the black and grey cables from the hive until and put them into 1 and 2 on my photo,I’m assuming the current wires connected need to be disconnected? many Thanks

Thanks Chris I was planning to install the Hive control unit by the boiler but I will check the wiring with my meter for sure.

Sorry to jump on this thread but I have a combi logic boiler with 2 off (two zones, lounge and rest of house) honeywell cm707 controllers and I want to convert to hive, I'm assuming it's pretty much straight forward if not similar to the original thread from Szemko. Question is the cables that...