Recent content by kenben

Thanks for your suggestions Chris, will double check these have been considered before going for the dreaded PCB replacement, cheers Eamonn.

Hi Tony, to be fair to my engineer I only asked him to pop in and fit the harness on the way to another job to see if that was all that was now wrong he's yet to come back and go through it thoroughly I am just looking for suggestions from the symptoms experienced in case someone else has had...

Hi Tony, to clarify, both the CH & HW had been gradually failing to operate properly over a period of months (struggling to fire-up reliably & keep alight) then the HW failed completely and a few days later the CH as well. I had found I could usually get the HW to work by firing-up the CH first...

Appreciate the picture, its not far off the mark. I'm still laughing, the payout was more than the boiler cost (almost inc. fitting) !

Hi Tony, thanks for the quick response. Having searched various forums it seems similar problems with Halstead combi's all over the place though most seem to have the problem with HW exclusively or HW&CH rather than just on the CH side. Spoke to Halstead Technical this morning and they suggested...

I have a 3 year old Finest Gold which works perfectly for hot water but when I switch the CH on it fires up fine for about 40 seconds max then shuts down but red lockout led doesn't illuminate (except occasionally after many start-up attempts) and the hot water continues to work perfectly. Does...