Recent content by Kevdiy123

Cheers

Is it a transformer for every light?

Hi One of our bathroom lights stopped working a while back despite replacing the bulb. Finally, go round to taking a proper look. Bought a replacement lamp holder with wiring but the light still doesn't work. It is showing a voltage through all the wires but tried several different bulbs and it...

No it's just a crack. Light fitting wire bends away from it

Hi I have removed a few some 'lovely' textured ceiling paper. However, I am left with several cracks in the ceiling plaster. The ceiling has very little movement so planning to just get on with decorating it. My question is should I just fill the cracks and paint over them or wallpaper then...

Thanks this worked

Hi hoping someone a lot more knowledgeable than me can assist. One of our security lights is out. I suspect it is the light not the sensor as the light is a lot older. I would like to attach a smaller light to the circuit rather than replacing the original light (it is about 5 metres up and...

Thanks for everyone's input this was a wiring issue which Sunray's image solved

Yes turn cord off and turn it back on a fuse box and light works. Pull cord and it trips again

Hi all Fitted a new light in our closet. Existing wiring just a different light fitting. Worked fine before. Now when I turn it off it trips the system. Thought it was the fuse near the light but turns out there was never a fuse in there anyway. Wires appear to be where they were originally so...

I fitted a new euro cylinder but it is faulty. I can't remove it because it won't turn enough to release. It turns a few millimeters but won't move the deadbolt starting to panic as it's getting late and gate lock the door. Key is also stuck in lock as it won't turn enough to release it. Any...

Hi We own a 1850s (may be earlier) stone house and have begun exploring whether we can expose the fireplace in the living room. We have located the height at which the original (very large) stones are. Below that is loose (by just touch) smaller stone. However, on the sides of the current...

Unbelievably, it was just the reseting of the nest controller that got it working. There's a day I will never get back. Thanks for the suggestions

Set up attached. I have reset my nest panel and hot water is now leaving the boiler but not making it to the diverter valve pipes.

Hi A bit puzzled at the moment. I removed a section of central heating pipe that had a screw put through it. Since then we have had no hot water or central heating. To solve the issue so far I have done the following: - Bled all the radiators (alot of air released from those near the fixed pipe...