kevinsmbuk's latest activity

  • K
    So you reckon that even with the chipped edges of a wet cutter they will look alright on a bead? Tried using a normal tile cutter. But...
  • K
    I get that, I have found the centre point and roughly run off that, but whatever I do I wasn't going to end up with a full cut on the...
  • K
    It's got like a 1mm lip, wouldn't hide a tile cut by a wet tile cutter. The one I'm using leaves a rough edge.
  • K
    I have 600 x 900 tiles. I am at an internal corner with a 450 cut, would you normally start the next wall with a 150 cut then full tile...
  • K
    I'd be pretty surprised if merely replacing the channel ever resulted in an effective screen but I guess if you were going to revamp the...
  • K
    We are retiling as we had a leak related to a bad tiling job by the previous owner. Walls have been properly tile backer boarded so it's...
  • K
    I have a shower screen chanel (bit the screws to the wall) which has been damaged when trying to prise away from the old tiles...
  • K
    kevinsmbuk replied to the thread Plumbing sink.
    OK I guess it gets us up and running for the moment, the issue with that is there is no drain connection for the dishwasher. So I need...
  • K
    kevinsmbuk replied to the thread Plumbing sink.
    That's a fair point. In the end I connected it this way, hopefully that's ok?
  • K
    kevinsmbuk replied to the thread Plumbing sink.
    The overflow is properly connected on the full size sink, the the dishwasher waste is connected to the half bowl which doesn't have an...
  • K
    kevinsmbuk reacted to Hugh Jaleak's post in the thread Plumbing sink with Thanks Thanks.
    Dishwasher waste hose needs to rise up to almost level with the underside of the sink before dropping to connect to the spigot on the...
  • K
    kevinsmbuk reacted to terryplumb's post in the thread Plumbing sink with Thanks Thanks.
    Remove the dishwasher waste pipe , and fit the overflow pipe work as it should be. Fit a trap with an integral appliance waste inlet to...
  • K
    kevinsmbuk reacted to denso13's post in the thread Plumbing sink with Thanks Thanks.
    If you've used up all the bits that came with it them something like this, https://www.toolstation.com/mcalpine-p-trap/p74016, should...
  • K
    kevinsmbuk reacted to Madrab's post in the thread Plumbing sink with Thanks Thanks.
    Why is it Blanco always seem to insist in coming up with the most awkward and pointlessly complicated waste systems known to man. I'll...
  • K
    kevinsmbuk replied to the thread Plumbing sink.
    Cheers for the advice the only issue I have is it has quite stylish drainer plugs, so if we ditch all that well lose that too won't we...
Top