Recent content by KingboyD

Evening! Going to have a go at patching up external garden wall that the render has fallen off, I was going to use a bag of ready mix concrete from Wicks but before I do can anyone else recommend a product I should use or will concrete do the job see attached picture! Bear in mind I have no...

I don't know how long it was that bad for but it must have been a good few hours! So you think it's best I give them a call!?

You would have thought so but nothing visible outside, I could hear it flowing out so it was deffo leaking at that rate. The kitchen & the middle room in the house (old terrace house) are concrete, the front room is floor boards with a cavity.

That's about the flow rate the combi kicks in so a decent amount of water flowing.

Thanks for you're reply Terry! Yes the cold feed really could do with being re-routed, it must have been a reasonably sized hole in the pipe as the flow was enough to kick up the boiler for hot water demand, just concerned as to where the water is/will go hehe

Had a burst pipe in the kitchen under the floor (concrete with old tiles on top), it was the old redundant hot feed to the washing machine that is buried in concrete to run from 1 side of the kitchen to the other, it must have been leaking for about 12hrs, at its height it was enough to kick up...

Hi, is there any problem regs wise if I spur off the ring main to a fused spur point to power a wall mounted electric fire? Thanks

Love this flushed system! Much quieter than the old one & a far better more powerful flush! Not on a meter :D

Excellent thanks!

My bog no longer flushes, it has a standard syphon installed, Im thinking of getting this part as a replacement...... Fluidmaster Pro Series PRO750UK lever operated dual flush valve This will fit & work as a direct replacement won`t it :D Toilet is a close couple cistern. Thanks

Yeah the new pedal is identical to the old one! No strengthening what so ever!

John they are not hard to get off :) welding it in situ must have been tricky! DIYSpanner - you know what I mean about cable tieing the spring? Cable tie it like they are spring compressor something on a strut, makes this awkward job a lot easier!! Also make sure you don't forget to remove the...

Here is a pic of the end plate of the box section that the clutch master cylinder rod lives in! Ok bear with, trying to do this on my phone!

This is the thing, it's not a different setup! A Bora identical to a Golf, I have owned & repaired Golf's for a long time, had a MK4 which is the platform we are talking here for 12 years, the black plastic clip is the shoe contact for the clutch switch & nothing else. What's happened is the...