klaus_k's latest activity

Follow-up - fwiw I am now a ferrule-fan. Much easier than fiddling with wires that keep untwisting.

FWIW, the hack worked a treat :) Biggest issue was finding a couple of hours when I could work outside, when it wasn't raining. Thanks...

I believe that is the arrangement OP is seeking, ie if either or both PIRs switch on the 2 lights, they will not extinguish until both...

You are correct!

To OP. I have heard people call the arrangement you require as 'All master', 'Master/master'. You seem to be describing quite well your...

Since it has a neutral connected likely it will work. And it is unlikely to cause danger, I would swap the three connector block and...

Impudence by name... either can be a master, in which case it become the master of the other lamp, which is the slave.

Thanks @SUNRAY. If it doesn't work then tbh I haven't lost much - I can't seem to find any outdoor lights that officially claim to...

I personally have done exactly that a number of times and so far without any issues or promlems. However I hope you understand that I...

Stretching the question a bit (sorry). This is the light that got delivered - which does not officially support a master/slave...

SL??? What's that? Replacing existing light fittings, on front and edge of garage, out front of house.

Thanks @ericmark , but do these points invalidate @SUNRAY's advice, or are they just a general comment on how PIR's work?

That is fantastic - thanks. And yes, I do have an override switch (indoors) that allows me to 'force' the lights on. Such a clear...

Hi, I currently have two outside lights, each with a PiR sensor. They have developed a fault so that the sensor only works some of the...