Recent content by klystron

Hi, i registered with the NICEIC and they sent me through a book on testing and inspection. I have had a look at the books that were mentioned in this thread and they are very good.....

All comments were very helpful, much appreciated thanks.....

All, thanks to those that actually tried to help. The tester manual that comes from fluke might as well be used to wrap fish and chips..... I have found the info that i need and didnt realise how easy it is. Thanks again.....

I have tried to get the 2391 course booked but it is not available until November!!!!! Is there a book that shows you where you should connect the test leads for each test, especially the insulation resistance test. I know i sound like a bit of a muppet but not used to these...

Hi all, I have just purchased a Fluke 1651 tester and am not quite sure how to test circuits as the instruction are very vague. The tests that it can perform are as follows: Continuity Earth loop inpedance Insulation resistance RCD testing Does anyone know of any good websites that...

Hi all, can anyone tell me how to work out diversity when designing a electricall cct. Thanks alot :D

Hi, here is my question. Can you run a fuse spur from a ring main to supply a lighting circuit :?: I would like to put some under cupboard lights in my kitchen but cannot get power from the light, there is a socket in close proximity the i could spur from if it is allowed. many...