Recent content by kneebs76

I sit writing this from the comfort of my warm flat :-D Nice, simple 2 minute soldering job...just what I like! I'm just thankful it was the electronic side rather than any plumbing job....I think i'd of had to call in the experts for that! I'll get it serviced soon, then if it goes again...

Well I've took the PCB out & found one or two cracked solder joints but I think this is the problem - it's one of the legs from one of the relays.. Looks like it's been arcing a while.... Uploaded with ImageShack.us

Hi Tony, Yeah mate,I got the multi-meter out and the voltage drops from 24.3 > 0 when closed... I know what you're saying with regard to repaired PCBs, but the difference of ~£150 appeals to me lol! My alternative, is, is that I get domestic emergency cover as part of my bank account...

thanks for your replies everyone.... From going through the fault finding diagram 1 & 3 here (towards the end) ... http://www.partsarena.co.uk/baxi/System/DATA/Dx/DS1/installation/2511/I19-2511/I19-2511.htm ....it looks like it's a faulty PCB - the pump works, as I can hear it, and the CH...

Sorry, forgot to add, yeah, checked pressure & was just under 1 bar - I've topped it up to 1.5 but that's made no difference.... Cheers

Hi I've got a lynx 2 which was working fine when I had the CH on, then about an hour later I went to take a shower & no hot water :-( The CH doesn't heat either now - when I turn a tap on for HW, the water heating light comes on, and there's a quiet 'whirring' within the boiler, but no...