Recent content by KrashBandiKoot

Design? Design what exactly? An electrical system? LMAO!!! Yeah, there's a real lot of "design" going into ensuring there's a series of sockets available near to work benches. And of course there's a hell of a lot of "design" in ensuring that light is cast where it's needed eh? Don't talk...

The electrician is required ONLY for the final connection - From the workshop to the consumer unit in the house because I don't the relevant JIB registration, wire seals or sticker seals to reseal the 60amp main fuse. If I had the wire and sticker seals I'd carry out the work myself and save...

Actually, 20 odd years ago I was installing fire alarm systems on inshore oil rigs and rewiring domestic houses so I'm good on the actual installation. I don't mind leaving socket and switch faces off for the electrician to check the work/connections before certifying it. The issue is my...

Just to clarify, it's not a garage, this is a custom made workshop built from the ground up out of wood so I can avoid the obvious planning permission as it won't be a permanent structure/ As far as tools go, to list the main units : Table saw Routers Ben joiners Drill press Miter saw...

Hi folks, I found this forum when I was looking for a bit of help with a 2 MCB fused consumer unit I'm going to install in my workshop. OK just to outline what I'm doing, (in order to get the best advice I can), I'd like to double protect my tools and workshop by having a single cable from...