Recent content by krill

Hello Derek, I assume that’s an attempt at humour, sorry but not very helpful but if you have nothing better to do then so be it

Hi, I want to install a 3m load bearing lintel for a 2.7 opening, one end will have plenty of bearing but I want to fit the other end into a cavity wall which will only give me 100mm, what is the best way to do this? Any help appreciated

Thanks for the replies, the boiler was second hand, working when removed, it was commissioned by a corgi heating engineer who said it could take him a long time to find the fault and advised me to try the internet for a solution, the boiler cycles just as fast when the rads are cold so there...

I have a Ravenheat boiler model CSI 85 A, the water works fine with continuous flame but when the heating is on the the boiler ignites then cuts out cycling about every 20 seconds or less, the radiators all get hot and there's no air in the system, can anyone advise or guide me to what to check...

The gas supply is fairly new I think and in 22mm copper from meter to boiler with 15 taken off to hotplate and fire, it all looks fairly recent, is it possible there is a problem with the meter, how could the pipe become blocked?

I have just fired up new Ravenheat combi and the water and heating only reaches luke warm, also when the boiler is running the cooker hotplate flames go down to about half, I also have a Flavel Emberglow that soots up the glass in about a week so i'm thinking the gas pressure is low, is this...