Recent content by kyky

im looking for a recommended place for a 12foot rsj in cardiff area can any1 help

misses! wants a staight wall now, not curved!

i want to dot an dab a small curved wall can i dab straight onto fresh plaster or shall i coat it first with thistle bond it

ive cut out chases for pipes and need to now patch in with sand-cement any ideas wot to put over pipes prior to render

id first tack ply up 1side to work off, then remove ply during last few trowels to trim back access or id use stop bead an finish edge with decorators coulk prior to paint

iv hacked off old render to existing brickwork in my living room, i want to dot an dab over this brickwork but is still very dirty and dusty any ideas for the best possible key for the dabs iv tryed cleaning them with water and thinking of sealing with pva any advise

door has dropped any ideas on repairing

i thought ov a bell bead so i could get a good base coat on but the most i can go is a 10 mm stop bead to bring it flush with the bricks, i will try an get the worst off an giv that a go,thanks 4 the advise

i drained the water out of the rad then refilled coz it was smelling like curry since this the temp light as been on an stays on until i unscrew the rad cap an leave it off but i dont like the idea ov leaving it off so iv gota get it sorted. iv changed the thermasat but still no joy,theres also...

is there any way ov getting a better key to the painted blockwork without using mesh as it would stick out proud ov the brickwork

can any1 advise iwant to take down my living room wall how do i check if its a load bearing wall coz if it is i will need a lintel the length of my house which i dont really fancy

can any1 advise, i want to render my garage using weber,the problem iv got is that the blockwork has been painted which wont b enough ov a key and cant use mesh becausei will pass the finished brickwork at the bottom, has any1 got any ideas coz its doing my nut in