Recent content by large519

Hi again rocks, your thoughts please on same issue, I spoke to emw about issue with pcb, they said there is nothing wrong with it as they tested the relay before it was sent out, they said pressure switch needs replacing, so bought a new one and fitted it, but (not sure how far into cycle or...

ok, cool. Just for future reference incase it is the heater module, does the module look like the element that is in the bottom of kettle??Also where about is it located and how best to access it??

ok, will send it back first before replacing heater element, so is my pressure switch ok if it clicks when you blow into it??

ordered pcb thursday received it yesterday and fitted it today, i'm sure they would've tested it all though, wouldn't they?? Is the heater a costly replacement?? and easy to replace??

The wash enhance button is the top button of the set of lights on the left that go vertically. Looking at a chart of error codes it say F08??? heater relay change module and pressure switch?? is this correct??

Hi Rocks, Probably get bored of the same questions but, my machine runs a full cycle ok and empties ok, and the door unlocks but at the end the wash enhance and on/off button still flashes, I have already renewed the pcb from emw, as all the lights use to flash and it wouldn't do anything also...