Recent content by lee32

Thanks dc, do u mean the overheat cut out or the c.h. sensor

Had a quick look at it , didnt have a multim with me . Power up and pump runs without a demand . Put a demand on , nothing happens pump just keeps running no power at aps or fan ? Any ideas anyone . Thanks ....

hi ,brittony combi se, dumping pressure out of prv valve but only on heating, if heating is not used hot water works ok , and keeps pressure , when heating is used the pressure leaks out of prv ,, ?

so u dont know them to have poor flow rates or noisy operation as opposed to seperate booster pump and standard mixer shower

thanks for your reply , i believe he was getting an aqualisa digital with built in pump, the digitals i have fitted i have found them ok and fairly straightforward to install , but never fitted a pumped version, so its a thumbs down from you?

check the air pressure switch either with a mutlimeter or by shorting it out. if this is okay the chances are it is pcb.

hi, can anybody share any information about digital pumped showers, i have been asked to fit one for a client , i have fitted a few digital showers ,but not one with a built in pump, for gravity. anyhow the client phoned me yesterday and said he has heard the pressure is not as good as a...

your cold supply to the bath is tank fed swop it over to mains pipework and this will solve your problem. much cheaper and easier than boosting supply via a pump.

it is water hammer by the sounds, basically securing the pipework should stop it. try altering the flow by reducing the inlet flow slighty if u cant access the pipe.

for 3700 pound mate i would make sure the the full system is repiped.thus solving any previous problem.

is the running water sound the pump running

thanks for your help kev i returned this morning removed diff, cleaned it out and altered the throttle on the bottom of diverter any how she fired and i have not had a call back yet!

ye everything was fine when i left, the boiler fired first time when i put the water back on fired it in an out repeatedly no leaks this was on friday i got called back today late on, an had a quick look ,going back in the morning , the microswitch is engaging the switch just not quite enough...

ye kev i changed the whole valve assembly

hi kevplumb , sorry i have just read my post and i didnt say it is a turbomax ,how thick is i