Recent content by leejohn

Thank you all for the replies. I will have a look at the Smiths range of heaters. Is any model better than another ?

Has anybody had any fitted. If so what do you make of them ?

It was just a case of laying and securing the heating cable down then fixing the tiles on top. Id prepped it all the work before. Got up one morning worked out where all tiles needed to be. Mixed the adhesive then started laying them. Id completely forgot about the heating ! Luckily...

So after levelling the floor of my new kitchen extension I proceeded to tile it throughout. I took my time doing it. Everything was nice and level and even with a large kitchen island to contend with all tiles lined up exactly. Grouted it all and cleaned it. Well chuffed with it. A few...

In my sons bedroom a single switch on wall turns on two lights. One ceiling and one on wall. Is it possible to control each light separately from their own switch ? If possible how would they be wired ? Thanks in advance. LeeJohn.

Ihave a Mixer tap on my kitchen sink and the hot water side will not turn off. Its in full flow.!! Ive had to to turn water off at the stopcock.!!! Ive taken the knob off the hot and inside I can see three small holes. there are black washers ? with springs in. Can anyone help !!

The waste will go into a hopper so a shallow p would do. I just dont want to be running the waste under any floorboards. But if a shallow p will fit I may go for that. thanks for the info. Tony.

Thanks for the reply. Sounds like that will save me a lot time .

So 15 mm pipes will be ok then. Cheers. Sorry if my first post did not make any logical sense to a few but one was a bit rat arsed whilst posting it ! Nice to see theres plenty of humour on the board. Regards. Tony.

Running off a combi boiler, will 15 mm pipes be ok to fill the bath. ??

Im about to install a freestanding bath. Does the waste have to be fitted to flow under the floorboards or will their be sufficient room to fit a shallow P trap ??