Recent content by LEGS

cheers fella's sound i'll do it like that. Yeah best i connect the back door up en :lol: i'll let you know how i got off thanks everyone! :mrgreen:

no entry will be through front door where the keypad is. Anyway if the kitchen pir would be activated if entered through back door. So best to use 5 zones? sorry to sound dim but i just want to get it right thanks to you guys!! :D Thanks in advance!

Hi thanks for your response!! Lay mans terms there are 8 zones i can use, zone 1 front door zone 2 back door zone 3 living room zone 4 kitchen zone 5 landing what will i have to do to the remaining zones? will i have to link them out on the board?? can you also tell me if its best to...

Hi can anyone please advise on how to wire 3 pir sensors, as the diagram in the manual only shows 2? What i plan to do is zone 1 are the front and rear door, zone 2 living room, zone 3 kitchen, zone 4 is upstairs on landing. Are there any better ways to do this or is my plan the best...

Bout three years ago i had the walls inside my house injected with some kind of damp course to stop rising damp. I was renovating the house and all render and plaster was removed and new floors taken out and replaced with waterproof membrane put underneath. Everything was well until about a year...

Bout three years ago i had the walls inside my house injected with some kind of damp course to stop rising damp. I was renovating the house and all render and plaster was removed and new floors taken out and replaced with waterproof membrane put underneath. Everything was well until about a year...

Thanks fella's 25mm sq tails it is to swith fuse and swa to cu. thanks again! :D

sorry i didn't mean 10mm sq tails they are 16mm sq. I want to keep the cu in the original place inside the house? Is this any clearer? Is there a rule for how long the tails sholud be?

I am having an extension on the side of my house and the meter box has to be moved to the new outside wall. The current tails from the meter to the cu is 10mm thick and about 2M long. When the meter is moved it will be about a 10M run to the consumer unit, will 16mm tails be sufficient or will...

Sorry didnt mean to affend anyone. Jus after a bit of help. on the circuit there is a socket and rocker switch together, then it feeds the outlet plate. i thought the socket would be protected by the appliance fuse and the 1.5mm cooker cable by a 16A mcb. am i right to say a 1.5mm cable can...

A COOKER IS RATED 2950W IT SAYS IN THE MANUAL TO USE 2.5mm. CAN I USE 1.5mm HEAT RESISTANT CABLE FROM THE COOKER OUTLET TO THE COOKER? AND WHAT SIZE MCB WOULD BE SUITABLE?