Recent content by LEVI_DRACO

@big-all i thought so...but I don't see where they would slide into...but they are the exact size to fit under the small extention plate ...but not in a fashion that I can extend it even further...maybe just for extra sopport for the plate..im not sure

They seem to fit perfectly in the 3rd (smaller) table extension ...maybe for stability ...im not sure but that's exactly what I did and place them there until I find another place for them. I was wondering if they were an outfeed assembly ...but the holes in the extension plates are too small...

It's a Hoteche 254mm 1500 watt 10 inch table saw...and I have the manual...it's just a useless and vague manual that didn't have anything about that piece...I also had a hard time putting the riving knife but I think I got that installed correctly now... I just have those 2 extra pieces that...

I bought a brand new 254mm 10 in table saw but the instruction manual wasn't very helpful...I ended up with 2 rods with a threaded hole and unsure where those get placed...can anyone tell me what they are for?? I've included a photo of the rods