Recent content by lfnfan

Nice one - thanks for the suggestion! I have a bunch of felt I can use to give it a go, so that's a low-cost thing to try. I will report back!

This is really interesting. Truth is I don't know if I need dense or not. I have a whole bunch of dining chairs with hollow metal legs that make a proper racket scraping on the hard floor whenever we get up or sit down. After putting felt on the bottom of one chair legs, I don't think the...

Hi @opps - thanks very much for your response. Really appreciate it. Yes, sorry, 400mm length, not depth. Interesting I had seen the gun variety but wasn't sure. That definitely sounds like the right way to go to avoid shooting the foam all over everywhere. Are any foams more heavy / dense...

Hi I am looking for recommendations for a really dense expanding foam that I could use to fill lengths of 20mm square section tubing to a depth of 400mm. Would also be grateful for advice on best method of application to ensure I reach the desired depth (and without getting expanding foam...

Looking for recommendations on product to use to get a watertight seal for joints in my driveway channel drain. I will need to seal a joint between concrete and the floor of the pvc drain. I will also need to seal joints between sections of the pvc drain (around 1mm where they butt up against...

I can see that - it's a way better design than the round one. If either the J501 or the J804 would do the job I think I might go for the J804. That way I can have the T&E with the incoming power entering the J804 from one side and the two sets of T&E for the fans exiting the other side of the...

Nice. Not seen that before. My application is two inline extractor fans, each 25W, 240V. located in loft space secured to joist. Would the J 501be suitable?

Hi I will be using one of these junction boxes (20A version) with three 1.5mm T&E cables. I can't find a picture of the internals but it has four 'pillars' each with a tighten-down grub screw. My question is: what is the best way to secure the cores so they make a good durable connection? I...

Thanks elite123. Mottie - that's the approach we've been taking for the last ten years! Thought it might be time for a change....

Hi All i'm looking for some advice on materials for soundproofing around an existing en suite toilet that already has some soundproofing in the stud wall it's made from. The main problem is the sound coming from the wastewater from the toilet flush and cistern refilling that can be heard in...

Happy to report success. One leak-free pressure washer! Result. Let's see how long it lasts.... Cheers

Quick update - I managed to prise the motor cap off the motor housing. There are two chubby gaskets (as in pic above), one at the top and one at the bottom which I guess should be forming the seal. They seem in good order, but the lower one has some white sludge on it so maybe it's not sealing...

Hi Blup, thanks for that. I don't think the problem is in the cylinder head - there's no leak coming from there. The leak is from the bottom of the unit between the motor housing and what the diagrams call the 'motor cap'. I'm not sure bit it seems like unpressurised hose water actually...

Hi All Would really appreciate some pointers on how to fix my leaky Karcher K4 Compact. The machine still works but unpressurised water dribbles out the bottom of the motor housing, from the gap between the silver and black parts (the motor and housing), shown by the blue line in the picture...

Nice one - that's very helpful indeed. Will get stuck into this. Thanks again!