Recent content by LoonyMonkey

Just pulled off fsu and mess of wires in there that's Beyond my skill level, one last thought could I remove the danfoss and wire the Wireless receiver using existing cables

Thank you very much

Thanks for taking the time It all on same switch as the power go off at stat when I turn it off boiler not that it matters as you say but here is photo of stat I have just found manual and it's the tp5000 si range think there is rf version but it not this model or setup

Here is a photo

The stat is a danfoss tp5000 and is wired with live natural earth and SL and a jumper wire Boiler side has single live natural earth and the SL with the 4 port empty on Boiler terminal block Then I have 3am fuse switch that I haven't taken off wall yet. All the cables them self are within the...

Thanks for the reply just so I got it straight as it a stat programmer no bridge is needed just isolate everything Individually behind the old programmer?

Hi I want to install a tado wireless bridge at the boiler so I need to remove or bridge the old stat. I understand that you connect live and switched live in wago and the just cap off earth and natural in it own connecter where old stat was. What I don't understand is what I do with the SL at...