Recent content by LukeMc84

It started mostly clear, then a copper colour towards the end.

No, I thought I'd wait for a response before putting in the x100. I didn't realise that a filter would be needed/useful. There wasn't really any 'sludge' when I rinsed the system the first time, just dirty water. The rise was a precaution rather than an attempt to fix a problem as the system...

I've recently emptied my system after circulating sentinel x400. The packaging says "thoroughly flush through ALL drain points". I checked all of the radiators and found only one drain point, emptied out the system, let it fill and emptied it again. When I went to switch the boiler back on I...

Job done, thanks.

13A I get what the colours mean, but the wire from the FCU must connected to a secondary place that I can't locate if a newer wire then leads into the PCB. I was just trying to trace the drop in V from the FCU is all.

I have a Potterton Suprima 30 connected to a boilermate II, they are about 11 years old and today I had no hot water. The boiler isolation fuse is fine and there is electricity leaving the isolation box. There are no LEDs illuminated on the boiler and I tested the 'mains' in to find no supply...

I recently noticed a dripping from what I assumed to be the overflow form my Boilermate II. I (mostly) emptied the F&E tank, gave it a wipe down and then realised the whole time the ballcock hadn't been trying to refill the water. On closer inspection it looks like I have previously (and I'm...

The heating pump does not come on when I switch the heating on. Does this definitely mean it's the pump at fault or could it be some other problem(i.e. "on" switch not sending power to the pump correctly)? The pump does seem very hot to the touch if that means anything. Is it a...

Hi, I was wondering how you go about checking if the Central Heating pump on a Boilermate II is working? I have recently lost my central heating, but the hot water is fine. The analogue timer on the Boilermate is still counting round, does this mean that this is not the problem? Thanks for...