Recent content by lums

There are many installers who fit Visonic over other systems.

Visonic is very good and Powerg has a much better operating range than Pyronix. If you purchased a 3g alarm today then the likely hood is that when 4g comes online your alarm will continue function just not on 4g. When people say Visonic isn’t very good they tend to say it based on 1. Powermax...

I’d get a 141 or 160 keypad for it and it will be fine

Can you send a picture?

what panel is it? PM10, 30 or 33?

1. Factory reset. 2. Put in Sim and don't enable anything in CS. 3. Set private report to ring you. 4. Once sim is in try phoning the number see what happens. Is there an antenna on it? pretty much every time I have a problems with panels with GSM it is the sim and signal.. 5. once this is...

Set up as private report to ring you. Also see if Gsm report is enabled?

You can get the app on with Powerlink I’d look at that and 141 keypad.. what version panel and hardware do you have?

Did you get sorted?

Out of interest how long have you had you Powermaster installed? if it is compatible with the KP250 I would say 5+ years, there are many good alarm systems out there Pyronix been one of them but I would seriously question the motive for changing a full alarm system because your new keypad wont...

Are you wanting to fit yourself ? or have some one so it for you?

They have infra red, they are not the quality of full cctv but they are designed so you know why the system has activated and can act upon it..

Visonic do a system with Camera Pirs you can monitor yourself and see why the alarm has activated.

Both the same GSM for Complete (as long as not 3G version)

Look at Powermaster 33 with Camera Pirs in van ..