Recent content by macca71

Hi, I need to replace the temp sensor and the overheat thermo which are located within the combustion chamber on my cb24x. I have removed the cover screws and found it difficult to remove the cover, I didn't want to force it, anything I need to know? Also do I need to repressurise the system...

They should of removed the brickwork to the new dig level then laid the poly over it so that the old wall was below your new floor. I did forget to mention a few inches of stone on top of the soil before your poly and insulation if you did decide to do the job up to regs. Good luck.

It sounds to me that the wall was removed to just below the original floor level and the gap was then filled with concrete. For the job to be done up to buildings regs you should have a poly membrane covering all soil and lapping up the wall to the finished screed height, it should also lap...