Madrab's latest activity
-
And of course any shower valve or blending valve -
One pipe is near, the other further away Father Dougle! ;)
-
Madrab replied to the thread Warm water in loft tanks.Absolutely not - If the cold feed is warming up and expanding back up into the cold water cistern (CWSC) then I'd be checking out the...
-
Madrab replied to the thread 7 bar static pressure.An EV or shock arrestor could be used if there is excessive water hammer but if you get the pressure down to a manageable level then a...
-
Madrab replied to the thread 2 problem rads.:LOL: :ROFLMAO::LOL: Is it not a really small cow Ted
-
Madrab replied to the thread 2 problem rads.Is that Microbore - 10mm - or is it just the perspective of the pic?
-
Madrab replied to the thread 7 bar static pressure.Anything over 4bar dynamic can start to affect fittings and valves, increasing wear. I am slightly confused by the large difference...
-
Madrab replied to the thread Leaking HW Cylinder Flange.Nope, never found any kind of sealant to work when trying to seal water systems. Is it the actual tapping in the cylinder or the...
-
Madrab replied to the thread PTFE tape or Liquid?.+1 for tape, what I've always used so no need to change IMO. As suggested, tape around the olive in a compression fitting only if...
-
Madrab replied to the thread How to remove it.Some of these work where the wall disk is captured when the overhead tube is tightened into the wall plate elbow.
-
Madrab replied to the thread Reseal a Walk-in Shower Cabinet.As per the MI - normally just seal on the outside
-
Madrab replied to the thread Adaptor for old bathtub tap..Cant say I've ever seen a diverter that would fit that shape. As suggested replacing the tap would probably be the only sensible option
-
Madrab replied to the thread Gas fire ignition.Time to get a recommended independent in, Wildfire need the product and serial number to give a list of available parts. If it's only 4...
-
Madrab replied to the thread High Pressure shower valve.Once those locks are out then they should just pull off. It may be a bayonet type fitting where you might have to turn it through 90deg...
-
Madrab replied to the thread High Pressure shower valve.Isolate the hot and cold and then read what's on the connector to the left of the screwdriver slot - chances are it'll say either -...
