Madrab's latest activity
-
Madrab replied to the thread MDPE Protection.You can get specific insulated ducts for every size of MDPE. Shallowduct is the one I used to use for 25/30mm MDPE, from the same people... -
-
Madrab replied to the thread UFH mixer valve pin replacement.That's a contact temp sensing head - not a TRV (thermostatic radiator valve) though they do work in the same way. The vial sits inside...
-
As suggested try cleaning up a bit Looking at age of pipework that may just be a spring loaded safety valve covered in crud.
-
its an old fashioned safety valve from the 60/70`s under all that crude are relief holes it can be taken out and plugged off as they are...
-
Madrab replied to the thread Stixall Vs CT1.Water sealing what? Neither of them are a standard silicone which would be used for standard sealing, like baths, showers etc, they are...
-
Madrab replied to the thread MDPE Protection.Min trench depth in 750mm. Entry point into a property needs to be ducted, insulated and screened. As suggested there are other options...
-
We use the INSUduct system to bring water services into buildings less digging and ducting. I'd be looking to take pipework tight...
-
Madrab replied to the thread What is this bit that's leaking? (Baxi).Get a wire brush and clean it up to have a proper look but it does look like a male coupler into a 3/4" adapting tee. The tee may have...
-
Madrab replied to the thread Washing machine hose....If the appliance is located say in a flat etc then they can be handy as they obviously have the double barrier to avoid flooding. As...
-
A good quality normal hose will be fine, hot or cold. You want a bit of air getting into the standpipe, maybe need to trim the hose end...
-
Madrab replied to the thread Low pressure on shower.No need to change the pressure on the boiler, this has nothing to do with water pressure, that's just the CH system pressure. The rads...
-
Madrab replied to the thread Isolation valves for heating.ISO valves designed for (edit) hot and cold water aren't normally a standard for use in CH systems and TBH there isn't really any...
-
Madrab replied to the thread Tall rad not working (has never worked well), suspect lockshield valve?.The pump might be getting a little lazy if it's an old boiler and that'll mean the system probably needs balanced.
-
Madrab replied to the thread Double radiator with heat from 1 panel only.Pic?
-
Madrab replied to the thread setting flow rates on ufh.You need to know the pipe spacing as it has been set out and the size of pipe, that coupled with flow/return temps. There are BS EN...
-
