Madrab's latest activity
-
Madrab replied to the thread Plastic pipe advice 10mm or 15mm.If the system is 10mm microbore then keep it the same, reduces the balancing overhead. You can really only run 1 medium sized rad off... -
Madrab replied to the thread Pressure Reducing valve query.OK - TBH a 3 bar PRV wouldn't normally be used as part of a loop for a sealed system. Anytime a PRV would be used as part of a boiler...
-
-
Madrab replied to the thread Pressure Reducing valve query.1st off, that's the wrong gauge, that only goes up to 1 bar on a 3 bar PRV. That could be a verifiable check valve and the plastic cap...
-
Madrab replied to the thread Broken waste pipe.Something like this? So there's no access under the bath once is set down, so the waste has to be connected to the bath then it's set...
-
-
Madrab replied to the thread Broken waste pipe.Is it a free standing bath that has a skirt all the way to the floor?
-
Madrab replied to the thread Outdoor Sink Drain Pipe Fix?.As far as the regs are concerned, a waste pipe discharging into a gully should discharge below the grate level but above the seal but...
-
-
Cut a hole in the grid, and extend the pipe through it.
-
Madrab replied to the thread Broken waste pipe.The key is if it is solvent Weld (ABS/PVC). If it is then I have got away with a piece of 40mm cut lengthways before. That then has a...
-
Madrab replied to the thread What size pipe is this?.None at all, that I can see.
-
Madrab replied to the thread Installing frost protection on existing S plan system..I would also suggest all the pipework has a high quality, high rated insulation fitted too, if it hasn't already.
-
Madrab replied to the thread What size pipe is this?.https://www.diy.com/departments/mdpe-fittings-to-copper-pipe-connectors-20mm-straight-22mm-copper-/5060449709440_BQ.prd Basically a...
-
Madrab replied to the thread Installing hive mini hubless thermostat.The mini receiver is wired the same way. Power is connected from L and N (Brown and Blue), switching is performed by Grey and Black for...
-
-
Madrab replied to the thread Heat exchange clean DHW.Yes your local friendly GSR engineer should be able to remove it and do it with the right chemicals
