Madrab's latest activity
-
Madrab replied to the thread Lagging for an external condensate pipe.Watch the system pressure when the boiler is running, does it climb up over 2.5bar? -
Madrab replied to the thread Hep20 or something else?.Yup, that's exactly why and even then that may not have been enough if it was an ascending type spray bidet. Cat5 backflow protection...
-
Madrab replied to the thread Soldering copper next to a fitting.If it's only 120mm away then it's touch and go. The rag would need to be soaking wet and that may protect the plastic but in turn it may...
-
Madrab replied to the thread Minium room temperature, is there a limit?.With regards to what? Temps are usually taken at height so any temp measured below 5degC can start to drop into the frost zone @...
-
Most of those cleaners are not to UK standards and to comply it involves separate supplies. Check out different categories of water supplies
-
Not allowed, it needs it's own supply from it's own storage cistern.
-
Madrab replied to the thread Hep20 or something else?.As suggested, it is against UK regulations to supply an ablution device (bum gun) from the cold mains supply in the UK. This is due to...
-
Madrab replied to the thread Shower trap strange goings-on.Is the shower on the same waste run as another fixture that is used regularly? if so, there could be back pressure that is blowing the...
-
Madrab replied to the thread 110mm stack rubber seal.As suggested, these seals usually change with age and become hard/brittle or shrink and once undone, experience has shown that they...
-
Usually a bit more to it than that, if the seal is coming in and out easily I'd wager it has shrunk with age, and is unlikely to reseal...
-
Madrab replied to the thread Radiator Sludge.Bit surprised though, given the fact that sorting out and system sludge/restrictions would have nothing to do with Gas Safe or anyone...
-
Madrab replied to the thread Can my valiant ecotec run just a single radiator?.Any boiler can run just one rad but yes it will lead to short cycling and be highly inefficient.
-
Madrab replied to the thread Converting push fit to glued?.Yes - both pushfit and SW plastic waste pipe can be used with universal compression waste fittings. Glu'able pipe, i.e. solvent weld...
-
Madrab replied to the thread Converting push fit to glued?.For me it's a few things. Most of which I have experienced. Solvent weld is a bit like soldering copper, once it's glued properly then...
-
Madrab replied to the thread Converting push fit to glued?.Unfortunately, I think the problem here is that they could be bathroom fitters? Whilst not all are the same and your chaps may be good...
