Madrab's latest activity
-
Madrab reacted to HERTS P&D's post in the thread Bleeding a unvented non-combi boiler rads with
Like.
1. Get a bleed key 2. Look on YouTube for any videos. Andy -
Madrab replied to the thread Not Getting Hot Enough!.Has this only started since the new pump went in? No - the boiler shouldn't be short cycling, with all 12 of the rads (average sizes?)...
-
Madrab replied to the thread Backfilling around compression fittings?.Is it to be tiled? backfill that section with adhesive. Cut the tile as close to the pipe as possible and then use the correct tile...
-
Are the 2 motorised valves the same make/ model ? If so swap them over , so the one for heating is now connected to the hot water and...
-
Madrab replied to the thread Electrical Issue With Central Heating.If you're happy testing 240V then if there is no power on the pink to the valve (that will be the live brown) then either the programmer...
-
Madrab replied to the thread Washing machine waste hose.As a rule of thumb, I run the drain hose to rise at least as high as the machine, it can then drop back down to the waste its to be...
-
Madrab replied to the thread Moving kitchen plumbing.There's going to be a fair bit of groundwork required. An outside section where the services are currently located will need to be dug...
-
Madrab replied to the thread Freestanding bath..+1 - fire away
-
Madrab replied to the thread Freestanding bath..Hence the question to check there's is a joist in between for all it takes. I would presume there is one but always best to check...
-
Madrab replied to the thread Silicone after grouting.Yeah, understand, a bit of a pain for sure but better that than a call back later on with issues.
-
Madrab replied to the thread Do basin fixing kits work?.M10 screw bolts should be more than fine. As long as they are into well supported batons then all should be good.
-
Madrab replied to the thread Freestanding bath..Cant say I've seen many domestic floors done in OSB, maybe different down south tho
-
Madrab replied to the thread Freestanding bath..I wouldn't think that the joists centres would be 800mm which is what they would be roughly, if the bath width is 750mm and the joist is...
-
Madrab replied to the thread Freestanding bath..Is the OSB, OSB3 and is it 22mm? I presume there is a joist running the length of the middle of the bath too? So say 400mm joist centres?
-
Madrab replied to the thread I have a leak from the hot water pipes under the floor..The best way is to feed them onto the length of pipe before laying, that way you don't need to cut them. If the pipe is in and live and...