Recent content by maguire

Hi all hope you can help. 12v pos to 12V and 0V is neg.? using the NO fire relay to trigger 1, So from 0v up to relay back down to 1 If this right then I have a duff dialler as it does not power up M

See what I mean, spelling & grammer or is it grammar Who cares Not Me cos so there

Yep a baco foil vaporising fuse link M

This may well be for bending copper only Maguire

If you feel that a question is somehow personally infradignatatum then keep your mouth shut, if you feel that a thinly veiled jibe is better than advice then join the sociopath forums where you can happily post insidious comments to your hearts content ,yeah you know who you are M

I had assumed that the max across three phases would 63A for a single use but the tech details did not make this clear, also the same limits apply to the 125 & 250 A boards, Lec I had a look at the possibilty of MCCB,s but it appears these are available on the panel boards only because they are...

I am looking to replace a TP&N distribution board however, can anyone tell me why a board is rated thus,125A incoming &63A outgoing they are Hager Invicta range M

Result, well done Dev

Looks like it, your getting there, if you can get the board out get a magnifying glass and check all the solder beads and look for blackening along the silver foil tracks Dev

The fridge sensor is basically a thermistor, the resistance of which changes with temp, if you can get it out, then with a multimeter set on the lowest Ohms scale dip the end into some warm water and the reading will change, not by much but it should change The themal fuse I think that may...

how can i identify the diverter valve make, i need a new diaphram as it is not coming out far enough to operate the switches it will come out if i flick the push rod, is it just sticking or is it worn, it's a euroucal turkington 90, I am going to strip it of today,if it stops raining ! Maguire

oilfire combi nothing fancy just a timer and rad stats, don't want water tanks a constant source of trouble access, leaking, freezing, siezing, you name it I'v had it and I have had no trouble with the outside combi, I was hoping I could do this myself via a diverter but if it's going to be a...

I have added a self contained extension for holiday letting and I want seperate ch control Mac

I want to seperate two parts of my house whats my options for seperate controls as I see it I can. 1)install a seperate boiler 2) split the system some how what kit is available diverter valves, controls etc Mac

Short answer is Yes whenI was a refrigeration engiineer I did all the knowledge by studing at home sat the 16th ed wiring regs at a local college,study the 2391 did the assesment and I have just had my approved contractor pre assesment so yes by all means if you think you can, go for it you must...