Recent content by malio

Thanks Everyone, Got it fixed, was the Primary Thermistor, working fine now. ( At the moment ) Regards Malio. :D

Thanks Tony, When you talk about sludge in the HE, does this mean Heat Exchanger, because when i was trying to solve the heating problem ( pressure dropping overnight ) i thought it might be a small leak in the system and over 12mths put 3 leak seal additives into the system, could this have...

Thanks Bingobongo, I forgot to mention that i had trouble with the heating side of the boiler were the water pressure kept expanding when on, and dropping overnight to were it cut off. This was due to the balloon in the expansion vessal being deflated,which after being inflated again solved the...

Thanks Tony for your reply, The green light comes on when its hot,then the red when it goes cold, but sometimes it stays hot without going cold. Regards Malio

when the shower or hot water tap are in use the water is hot for about a minute then goes cold. Can anybody help. Many thanks. Malio

Hi, I've got an Aiwa NSX 5707 model and both tape decks have locked solid with tapes inside and no matter what I do the tape doors will not open. Any advice please. Many thanks Malio.

Hi agian, Sorry it's been a while, i've managed to re-pressurize the balloon in the vessal and it seems to have done the job. Thanks again to everyone who helped, I really appreciate it. Many thanks, Malio

Thanks Gasmick2, Will try that later and let you know later. Thanks again to all. Malio.

Thanks again, Is the schraeder valve the one on top of the expansion vessel where you pump up the balloon, also the boiler usually stays at 1.5 bar and only rises slightly after filling when cold in the morning. Regards Malio

Thanks for your reply. It is not passing water through the pressure release valve, I wonderd if the pressure chamber balloon needed pumping up, can this be done with a cycle type pump? Regards Malio

Hi, I've been having trouble with our Vokera Compact boiler, when the C/H side is set at 1.5 bar it works ok when running, but when it is off overnight the pressure drops below .5 and needs filling back to 1.5 bar again. I've checked all the C/H system (even under the floor) and found no leaks...