Recent content by Marc118

Yep, we have an immersion installed in the DHW tank.

Hi, Yep I know a lot about these systems but unfortunately not the Vaillant control side, hence the question about the controls. We've found various problems with the system at present including smart DHW cylinder piped wrong, TXV faults, superheat settings too high etc etc, i'm not asking...

Hi all, Has anyone worked on these ground source heat pumps before? We have a site where a couple of these are installed but we are having problems with the heating and hot water with them but I suspect it's caused by the controls/settings and was hoping someone would be able to assist in...

Hi Fezster, The greenstar LLH has 3 inlet/outlets on the secondary side. If I do decide to go for this, could these just be blanked and then if I ever do need individual pumps for the three zones, the at least the LLH is already installed. The low loss header would be about 1000-1500mm away from...

I've tried calling Mike at Ainsdale but got no reply, he's obviously a very busy man. I've managed to speak to an old colleague (who's Gas safe) he as experience of installing low loss headers on commercial systems but not so much on domestic. However, he's willing to help me installing it and...

Also I've just carried out a calculation found on this forum of 6 btu x the cubic footage of the house divided by 3.412 to give the Kw 22000 x 6 =132000/3.412 = 38.7 Kw plus 3kw for hot water. I've got mine set at 30kw but going off that, my boiler is slightly undersized as well although I...

The pump in my boiler is a Grundfos 15-75. My preference would be to keep the boier and install a LL header but I just can't find anyone with the knowledge and if they do know then they don't understand the controls side. I've rang three gas safe installer this morning, one said he had no...

Hi All, I've been having problems with my heating system since i moved into my house 12 months ago see thread below, the boiler is a Valiant Ecotec Plus 637 https://www.diynot.com/diy/threads/valiant-ecotec-637-low-loss-header-wiring.533599/ The guys that were supposed to fit the low loss...

I've started a new thread on this because it's no longer just about a low loss header.

Guy's sorry for the late reply on this. My wife went into labour since I last posted and I just haven't had chance to reply. The guys that were supposed to come and install the new LL header and associated controls has let me down. He said he's not available until the new year now and so I'm...

Do you have a photo of the installation showing your LLH? I'm struggling to imagine how it will look and if it will be unsightly.

Can I ask why you didn't go for the valiant wiring centre? I was hoping to have the boiler controlled from my phone with smart TRVs so what ever works I do, I want it to integrate in the best way possible.

before changing to a LLH, could I not just change the boiler pump to a bigger one or add one to the pipework to assist? Edit: Thinking about the second pump, there would be no bypass on the system for when all radiators close would there.

Instead I could use the end switch on my 2 port valve (assuming it has one) to power the pump, this way if the switch didn't open, the pump wouldn't run.

Did you do this without a wiring centre?